- Products / Store
- >
- CubeSat Kitâ„¢ Modules
- >
- Payload Interface Module (PIM)
Payload Interface Module (PIM)
SKU:
710-01766
$0.00
Unavailable
per item
The Payload Interface Module (PIM) is part of the SUPERNOVA™ nanosatellite architecture. The PIM provides four switched outputs (+12V_SYS, VBATT or +5V_SYS) with programmable soft current limits (up to 4A), a four-port 10/100 10BASE-T/TX Ethernet switch, a home for a PNI RM3100 Geomagnetic sensor (for use with a compatible ADCS), and other system/debug features. Full telemetry and control are provided via a SupMCU™ over I2C.
Flight Hardware | Flight Qualified | Space Proven
-
Information
-
Compatibility
-
CAD
-
Datasheet
-
Restrictions
<
>
The Payload Interface Module (PIM) provides a power and Ethernet data interface between payloads and the bus. The power interface consists of four switchable outputs at 5V, 12V or battery voltage levels with current and voltage measurements, PWM capabilities and and programmable current limits of up to 4A; this allows payloads requiring up to 67W to be powered if a 4-cell battery is used. The PIM provides a 4-port 100Mbps Ethernet switch as a data interface to both payloads and flight computers. Additional capabilities include: system I2C breakout, user-programmable LEDs and push buttons, 50Ω controlled-impedance pass-through, PNI RM3100 magnetometer interface for compatible ADCS's, synchronization clock to synchronize processors to the Ethernet switch. The PIM's SupMCU™ manages all of its functionality and reports on its telemetry via a SCPI-based interface over I2C, at speeds of up to 400kHz.
Payload Interface Module |
|
Payload Interface Module |
|
WARNING: Pumpkin products can expose you to chemicals, including Lead, which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
|